TB-9-2320-335-13-P
TRUCK, UTILITY: EXPANDED CAPACITY, IAP/ARMOR READY
TECHNICAL BULLETIN; OPERATOR AND FIELD MAINTENANCE AND REPAIR PARTS AND SPECIAL TOOLS LIST (RPSTL) INSTRUCTIONS
MAY 2008
TB-9-2320-335-13-P - Page 264 of 680
10-23.1. ENGINE LEFT SPLASH SHIELD MAINTENANCE
(SERIAL NUMBERS 300000 AND ABOVE)
This task covers:
a. Removal
c. Assembly
b. Disassembly
d. Installation
WARNING
Hood must be supported during removal and installation. Failure
to support hood may cause injury to personnel or damage to
equipment.
1.
Disconnect hood harness (1) from connector (2).
2.
Remove four capscrews (27), lockwashers (28), and washers (29) from plate (31) and splash shield
bracket (9). Discard lockwashers (28).
3.
Remove capscrews (34) and (36), plate (31), and spring nuts (30) and (37) from headlight
housing (35).
4.
Remove four nuts (33), capscrews (32), and connector (2) from plate (31).
5.
Remove nut and lockwasher assembly (5), capscrew (6), and harness and clamp assembly (4) from
splash shield (3). Discard nut and lockwasher assembly (5).
6.
Remove nut (7) and valve (8) from splash shield (3).
7.
Remove locknut (38), washer (39), capscrew (24), and washer (25) from support bracket (26) and
splash shield (3). Discard locknut (38).
8.
Remove capscrew (23), lockwasher (22), and washer (21) from airlift bracket (10) and
splash shield (3). Discard lockwasher (22).
9.
Remove locknut (11), washers (12) and (13), capscrew (19), and washer (18) from lower airlift
bracket (20) and splash shield (3). Discard locknut (11).
10.
Remove locknut (14), capscrew (17), and washer (16) from master cylinder bracket (15). Discard
locknut (14) and remove splash shield (3) from vehicle.
a. Removal
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Maintenance and repair shop equipment:
automotive (Appendix B, Item 2)
Materials/Parts
Eight locknuts (Appendix A, Item 76)
Nut and lockwasher assembly
(Appendix A, Item 134)
Four rivets (Appendix A, Item 262.1)
Locknut (Appendix A, Item 106)
Three locknuts (Appendix A, Item 82)
Four lockwashers (Appendix A, Item 172)
Lockwasher (Appendix A, Item 145)
Manual References
TM 9-2320-387-24-1
TB 9-2320-335-13&P, Appendix E
Equipment Condition
• Battery ground cables disconnected
(TM 9-2320-387-24-1).
• Hood prop rod and bracket removed
(TM 9-2320-387-24-1).
General Safety Instructions
Hood must be supported during removal and
installation.
Maintenance Level
Unit
INITIAL SETUP:
TB 9-2320-335-13&P
10-2
Back to Top
