TB-9-2320-335-13-P
TRUCK, UTILITY: EXPANDED CAPACITY, IAP/ARMOR READY
TECHNICAL BULLETIN; OPERATOR AND FIELD MAINTENANCE AND REPAIR PARTS AND SPECIAL TOOLS LIST (RPSTL) INSTRUCTIONS
MAY 2008
TB-9-2320-335-13-P - Page 270 of 680
TB 9-2320-335-13&P
10-24.1. ENGINE RIGHT SPLASH SHIELD MAINTENANCE
(SERIAL NUMBERS 300000 AND ABOVE)
10-8
This task covers:
a. Removal
c. Assembly
b. Disassembly
d. Installation
1.
Disconnect hood harness (39) from connector (20).
2.
Remove four capscrews (24), lockwashers (25), and washers (26) from splash shield bracket (10) and
plate (19). Discard lockwashers (25).
3.
Remove capscrews (13) and (22), harness (16), clamp (17), and plate (19) from headlight housing (14).
4.
Remove four nuts (21), capscrews (18), and connector (20) from plate (19).
5.
Remove locknut (12), washer (11), capscrew (29), and washer (28) from splash shield (1) and support
bracket (27). Discard locknut (12).
6.
Remove capscrew (32), lockwasher (31), and washer (30) from splash shield (1) and airlift bracket (9).
Discard lockwasher (31).
7.
Remove locknut (7), washer (6), capscrew (34), and washer (33) from splash shield (1) lower airlift
bracket (8). Discard locknut (7).
8.
Remove locknut (35), washer (36), capscrew (2), harness (37), and clamp (38) from splash shield (1).
Discard locknut (35).
9.
Remove capscrew (3), lockwasher (4), and washer (5) from airlift bracket (9). Discard lockwasher (4).
a. Removal
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Maintenance and repair shop equipment:
automotive (Appendix B, Item 2)
Materials/Parts
Eight locknuts (Appendix A, Item 76)
Locknut (Appendix A, Item 77)
Two locknuts (Appendix A, Item 82)
Two lockwashers (Appendix A, Item 145)
Four lockwashers (Appendix A, Item 172)
Manual References
TM 9-2320-387-10
TM 9-2320-387-24-1
TB 9-2320-335-13&P, Appendix E
Equipment Condition
• Hood raised and secured
(TM 9-2320-387-10).
• Battery ground cables disconnected
(TM 9-2320-387-24-1).
Maintenance Level
Unit
INITIAL SETUP:
Back to Top
