TB-9-2320-335-13-P

TRUCK, UTILITY: EXPANDED CAPACITY, IAP/ARMOR READY

TECHNICAL BULLETIN; OPERATOR AND FIELD MAINTENANCE AND REPAIR PARTS AND SPECIAL TOOLS LIST (RPSTL) INSTRUCTIONS

MAY 2008

TB-9-2320-335-13-P - Page 387 of 680

24-3

24-4. SPLASH SHIELD SUPPORT BRACKET REPLACEMENT

This task covers:

a. Removal

b.

Installation

1.

Remove locknut (1), washer (2), capscrew (4), washer (2), and splash shield (3) from bracket (7).

Discard locknut (1).

2.

Remove two locknuts (5), washers (6), capscrews (9), washers (6), and bracket (7) from frame rail (8).

Discard locknuts (5).

1.

Install bracket (7) on frame rail (8) with two washers (6), capscrews (9), washers (6), and lock-

nuts (5). Tighten locknuts (5) to 90 lb-ft (122 N

•

m).

2.

Install splash shield (3) on bracket (7) with washer (2), capscrew (4), washer (2), and locknut (1).

Tighten capscrew (4) to 15 lb-ft (20 N

•

m).

b. Installation

a. Removal

FOLLOW-ON TASK:

Lower and secure hood (TM 9-2320-387-10).

TB 9-2320-335-13&P

INITIAL SETUP:

Tools

General mechanic’s tool kit:

automotive (Appendix B, Item 1)

Maintenance and repair shop equipment:

automotive (Appendix B, Item 2)

Materials/Parts

Three locknuts (Serial numbers 299999 and

below) (Appendix A, Item 85)

Three locknuts (Serial numbers 300000 and

above) (Appendix A, Item 114.4)

Manual References

TM 9-2320-387-10

TM 9-2320-387-24P

Equipment Condition

Hood raised and secured (TM 9-2320-387-10).

Maintenance Level

Direct support