5-3
NOTE
Perform steps 3-6 through 3-8 only if supplemental heater is
installed.
3-6.
Locate, mark, and cut corner of cab enclosure panel (1).
3-7.
Locate, mark, and drill 0.154-in. diameter hole (5) in cab enclosure panel (1).
3-8.
Install grommet material (6) on cab enclosure panel (1) with RTV compound.
TB 9-2320-387-35-4
1
1
6
5
Figure 5-3.
Figure 5-4.
.50
2.375
1.750
6. GROMMET MATERIAL – MS21266-1N – QTY. A/R