TB-9-2320-387-35-4
SINGLE CHANNEL GROUND AND AIRBORNE RADIO SYSTEM (SINCGARS) AN/VRC-88F, AN/VRC-89F, AN/VRC-90F, AN/VRC-91F, AN/VRC-92F
TECHNICAL BULLETIN; INSTALLATION INSTRUCTIONS
OCTOBER 2006
TB-9-2320-387-35-4 - Page 24 of 109
5-8
TB 9-2320-387-35-4
Figure 5-11.
Section VI. FINAL ASSEMBLY, TERMINAL BOARD WIRING, AND TERMINAL LINK
NOTE
• Refer to figure 5-10 for wiring overview.
• Perform steps 6-1 and 6-2 if hole and grommet do not exist in
battery box.
• If installing 24V terminal board only, begin with step 6-6.
6-1.
Locate, mark, and drill 2.00-in. diameter hole (3) in upper right corner of rear wall of battery box.
6-2.
Install grommet (4) in hole (3).
6-3.
Secure terminal link (8) and fuse wire (7) to 12V terminal board (1) with two locknuts (6), and
install cover (5).
6-4.
Route wire (2) through battery box hole (3).
Figure 5-10.
3 X 24V FUSES, 25 AMP
POSITIVE FUSE WIRES
24V BUSS BAR
GROUND WIRE
VEHICLE BATTERY
12V FUSE, 15 AMP
12V BUSS BAR
GROUND STRAP
POWER WIRE
EXISTING VEHICLE POWER STUD
EXISTING VEHICLE BUSS BAR
EXISTING VEHICLE SHUNT
GROUND SCREW
VEHICLE BATTERY
4. GROMMET – 2400 – QTY. 1
6. LOCKNUT – 271175 – QTY. 2
7. FUSE WIRE ASSEMBLY (12V) – 12480568-2 – QTY. 1
8. TERMINAL LINK – MS25226-6N-2 – QTY. 1
1
2
3
5
4
6
7
8
Back to Top
