TB-9-2320-387-35-4
SINGLE CHANNEL GROUND AND AIRBORNE RADIO SYSTEM (SINCGARS) AN/VRC-88F, AN/VRC-89F, AN/VRC-90F, AN/VRC-91F, AN/VRC-92F
TECHNICAL BULLETIN; INSTALLATION INSTRUCTIONS
OCTOBER 2006
TB-9-2320-387-35-4 - Page 22 of 109
5-6
TB 9-2320-387-35-4
Section V. ASSEMBLY OF CAB ENCLOSURE PANEL
NOTE
• For 12V terminal board installation on models with rifle mount
bracket shown in figure 5-8, perform steps 5-1 through 5-3.
• If not installing 12V terminal board, begin with step 5-4.
5-1.
Remove lower rifle mount bracket (1) from B-beam. (Refer to TM 9-2320-387-24.)
5-2.
Locate, mark, and drill two 0.159-in. diameter holes marked A in lower rifle mount bracket (1).
Install 12V terminal board (4) on lower rifle mount bracket (1) with two screws (2), lockwashers (3),
and nuts (5).
5-3.
Install lower rifle mount bracket (1) on B-beam. (Refer to TM 9-2320-387-24.)
Figure 5-8.
3
4
5
1
2
1.35
1.50
3.00
A
A
2. SCREW – MS35206-230 – QTY. 2
3. LOCKWASHER – MS35338-41 – QTY. 2
5. NUT– MS35649-63 – QTY. 2
Back to Top
