TB-9-2355-315-10-1
TECHNICAL BULLETIN
RG31A2/A3 LIFT AND TOW PROCEDURES
JUNE 2012
TB-9-2355-315-10-1 - Page 20 of 64
0002-10
0002
TB 9-2355-315-10-1
33. Remove tow light cable (39) from stowage and connect to emergency tow lights (33).
34. Route other end of tow light cable (39) along disabled vehicle and connect to rear electrical connector (40)
on wrecker.
35. Set POWER switch (41) at rear of wrecker to ON position.
36. Set HIGH IDLE switch (42) at rear of wrecker to CONTINUOUS.
37. Push and release LATCH switch (43) at rear of wrecker. Engine speed will increase to approximately 1500
rpm.
WARNING
Keep out from under retrieval system and disabled vehicle when raised off ground
or personal injury or death may result.
CAUTION
Make sure all rigging is secure. Loose rigging can become entangled and cause
equipment damage.
Fully retract two tow cylinders before lifting disabled vehicle or damage to
equipment may result.
38. Push in LIFT CYLINDER control lever (6) to retract lift cylinder (44) to raise disabled vehicle approximately 1
ft. (30 cm) off ground.
Back to Top
