TB-9-2510-251-13

TECHNICAL BULLETIN

OPERATOR AND FIELD MAINTENANCE; INSTALLATION MANUAL (INCLUDING REPAIR PARTS LIST); FOR ADD-ON-ARMOR (AoA) AIR CONDITIONING

AUGUST 2007

TB-9-2510-251-13 - Page 127 of 624

2-111

TB 9-2510-251-13

HIDDEN

2-1.4

Installation of Air Conditioning Kit to M1025A2 with GSIE Add-on-Armor (Cont’d).

a. Install Compressor (Cont’d)

WARNING

Solvent used to clean parts is potentially dangerous to personnel and property.

Clean parts in a well-ventilated area.

Avoid inhalation of solvent fumes.

Wear

goggles and rubber gloves to protect eyes and skin.

Wash exposed skin

thoroughly.

DO NOT smoke or use near open flame or excessive heat.

Failure to

observe this warning could result in severe injury or death to personnel.

NOTE

To achieve good electrical ground, make sure no paint is present under

ground cables, in threaded hole, or on mounting surface.

(18)

Clean mounting surface where mounting bracket mounts to engine with solvent

(item 10, Appendix D).

(19)

Lower mounting bracket (25) and compressor onto mounting location in front left side of

engine.

(20)

Secure ground cables (26) to mounting bracket (25) with original bolt (27) and

washers (28).

24

23

Figure 2-167.

Clamp and Fuel Vent Line

Figure 2-168.

Mounting Bracket and Ground Cables

25

27

26

28

(16)

Loosen clamp (23) attaching fuel vent line (24) to valve cover stud.

(17)

Bend fuel vent line slightly rearward to clear compressor mount bracket.