TB-9-2510-251-13
TECHNICAL BULLETIN
OPERATOR AND FIELD MAINTENANCE; INSTALLATION MANUAL (INCLUDING REPAIR PARTS LIST); FOR ADD-ON-ARMOR (AoA) AIR CONDITIONING
AUGUST 2007
TB-9-2510-251-13 - Page 314 of 624
TB 9-2510-251-13
B-2
g. Remove/Install.
To remove and install the same item when required to perform service or other
maintenance functions.
Install may be the act of emplacing, seating, or fixing into position a
spare, repair part, or module (component or assembly) in a manner to allow the proper
functioning of an equipment or system.
h. Paint.
To prepare and spray color coats of paint so that the ammunition can be identified and
protected.
The color indicating primary use is applied, preferably to the entire exterior surface,
as the background color of the item.
Other markings are to be repainted as original so as to
retain proper ammunition identification.
i.
Replace.
To remove an unserviceable item and install a serviceable counterpart in its place.
“Replace” is authorized by the MAC and assigned maintenance level and shown as the 3rd
position code of the Source, Maintenance and Recoverability (SMR) Code.
j
Repair.
The application of maintenance services, including fault location/troubleshooting,
removal/installation, and disassembly/assembly procedures, and maintenance actions to identify
troubles and restore serviceability to an item by correcting specific damage, fault, malfunction, or
failure in a part, subassembly, module (component or assembly), end item, or system.
NOTE
The following definitions are applicable to the “repair” maintenance function:
Services.
Inspect, test, service, adjust, align, calibrate, and/or replace.
Fault Location/Troubleshooting.
The process of investigating and detecting
the cause of equipment malfunctioning; the act of isolating a fault within a
system or Unit Under Test (UUT).
Disassembly/Assembly.
The step-by-step breakdown (taking apart) of a
spare/functional group coded item to the level of its least component that
is assigned an SMR code for the level of maintenance under consideration
(i.e., identified as maintenance significant).
Actions.
Welding, grinding, riveting, straightening, facing, machining, and/
or resurfacing.
k. Overhaul.
That maintenance effort (service/action) prescribed to restore an item to a
completely serviceable/operational condition as required by maintenance standards in
appropriate technical publications.
Overhaul is normally the highest degree of maintenance
performed by the Army.
Overhaul does not normally return an item to like new condition.
l.
Rebuild.
Consists of those services/actions necessary for the restoration of unserviceable
equipment to a like new condition in accordance with original manufacturing standards.
Rebuild
is the highest degree of materiel maintenance applied to Army equipment.
The rebuild operation
includes the act of returning to zero those age measurements (e.g., hours/miles) considered in
classifying Army equipment/components.
B-3.
EXPLANATION OF COLUMNS IN THE MAC, SECTION II.
a.
Column (1) - Group Number.
Column 1 lists Functional Group Code (FGC) numbers, the
purpose of which is to identify maintenance significant components, assemblies, subassemblies,
and modules with the Next Higher Assembly (NHA).
b. Column (2) - Component/Assembly.
Column 2 contains the item names of components,
assemblies, subassemblies, and modules for which maintenance is authorized.
c. Column (3) - Maintenance Function.
Column 3 lists the functions to be performed on the item
listed in Column 2. For detailed explanation of these functions, refer to “Maintenance Functions”
outlined above.
Back to Top
