TB-9-2510-251-24
TECHNICAL BULLETIN
INSTALLATION, REMOVAL, AND PARTS INSTRUCTIONS FOR ADD ON ARMOR (AOA) AND ASSOCIATED COMPONENTS FOR HMMWV FAMILY OF VEHICLES (FOVs)
JULY 2005
TB-9-2510-251-24 - Page 36 of 212
TB 9-2510-251-24
1-26
2)
Install C-partition support mounts as follows (see figure 1-12).
a.
Locate C-partition support mount (1) on vehicle rear wheel house as shown in figure 1-12.
b.
Match drill four (two on each side of support mount) 9/32 inch holes through C-partition support mount (1) and
vehicle rear wheel house.
c.
Grind rivets flushed on inside of rear wheel house, as required, to ensure a flush fit of nuts (4).
d.
Install eight capscrews (2), washers (3), and locknuts (4) to secure C-partition support mount (1).
Torque capscrews
(2) to 10 lb ft (14 N
•
m).
e.
Repeat a. through d. on opposite side of vehicle.
Back to Top
