TB-9-2510-251-24
TECHNICAL BULLETIN
INSTALLATION, REMOVAL, AND PARTS INSTRUCTIONS FOR ADD ON ARMOR (AOA) AND ASSOCIATED COMPONENTS FOR HMMWV FAMILY OF VEHICLES (FOVs)
JULY 2005
TB-9-2510-251-24 - Page 38 of 212
TB 9-2510-251-24
1-28
3)
Install C-partition as follows (see figure 1-13).
a.
Apply Sealing compound to 16 capscrews (8).
b.
Position left C-partition (3) and right C-partition (1) onto vehicle.
c.
Install upper C-partition gap strip (15) onto left C-partition (3) and secure with four capscrews (2),
washers (17) and locknuts (16).
Torque capscrews (2) to 37 lb ft (50 N
•
m).
d.
Secure right C-partition (1) to C-partition gap strip (15) with four capscrews (2), washers (17) and
locknuts (16).
Torque capscrews (2) to 37 lb ft (50 N
•
m).
e.
Install lower C-partition gap strip (12) onto left C-partition (3) and secure with three capscrews (11),
washers (13) and locknuts (14).
Torque capscrews (11) to 37 lb ft (50 N
•
m).
f.
Secure right C-partition (1) to lower C-partition gap strip (12) with three capscrews (11), washers (13)
and locknuts (14).
Torque capscrews (11) to 37 lb ft (50 N
•
m).
g.
Install two each isolation mount bushings (5) onto two C-partition mount brackets (7).
h.
Install two isolation mount brackets (7) onto C-partition support mount.
i.
Install two isolation mount brackets (7) onto C-partition support mount.
Install two capscrews (10), two
washers (9), four washers (4), and two locknuts (6). Secure each bracket (7) with four capscrews (8) and
washers (18).
j.
Torque two locknuts (6) to 37 lb ft (50 N
•
m).
Torque eight capscrews (8) to 21 lb ft (28 N
•
m).
k.
Repeat steps g. through j. for opposite side of vehicle.
Back to Top
