TB-9-3950-253-13-P
PALLETIZED LOAD SYSTEM TRUCK, M1075 and M1075A1 (PLS) AND HEAVY EXPANDED MOBILITY TACTICAL TRUCK, M1120, M1120A2, AND M1120A4 (HEMTT), ENHANCED CONTAINER HANDLING UNIT (E-CHU)
TECHNICAL BULLETIN; OPERATOR AND FIELD MAINTENANCE, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LIST
JULY 2009
TB-9-3950-253-13-P - Page 277 of 704
0027-3/(4 Blank)
0027
TB 9-3950-253-13&P
REMOVAL – CONTINUED
4. Remove locknut (Figure 2, Item 3), washer (Figure 2, Item 4), and pin (Figure 2, Item 2) from stowage
assembly (Figure 2, Item 1). Discard locknut.
Figure 2.
Pin Removal.
0027
END OF TASK
CLEANING AND INSPECTION
00027
Clean and inspect all parts IAW WP 0020,
General Maintenance Instructions
.
END OF TASK
INSTALLATION
WARNING
During these procedures, personnel are required to work outside the vehicle where there
are several projecting parts, and personnel are required to bend down. Take care when
bending and straightening. A hard hat is required. Failure to follow this warning may result
in injury to personnel.
1. Install pin (Figure 2, Item 2), washer (Figure 2, Item 4), and new locknut (Figure 2, Item 3) on stowage
assembly (Figure 2, Item 1).
2. Install transport lock adjustable strut (
Figure 1
, Item 3), bolt (
Figure 1
, Item 4), and nut (
Figure 1
, Item 6) on pin
(
Figure 1
, Item 5).
3. Install transport lock adjustable strut (
Figure 1
, Item 3) and bolt (
Figure 1
, item 2) on bracket (
Figure 1
, Item 1).
4. Install clip (
Figure 1
, Item 7) on bolt (
Figure 1
, Item 2).
END OF TASK
END OF WORK PACKAGE
1
2
3
4
1
Back to Top
