TB-9-3950-253-13-P

PALLETIZED LOAD SYSTEM TRUCK, M1075 and M1075A1 (PLS) AND HEAVY EXPANDED MOBILITY TACTICAL TRUCK, M1120, M1120A2, AND M1120A4 (HEMTT), ENHANCED CONTAINER HANDLING UNIT (E-CHU)

TECHNICAL BULLETIN; OPERATOR AND FIELD MAINTENANCE, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LIST

JULY 2009

TB-9-3950-253-13-P - Page 357 of 704

0035-9

TB 9-3950-253-13&P

0035

REMOVAL – CONTINUED

Slider Assembly Removal

00035

WARNING

•

Lifting cables, chains, hooks, and slings used for lifting must be in good condition and of

suitable capacity.

•

Improper use of lifting equipment and improper attachment of cables may cause injury to

personnel and damage to equipment. Observe all standard rules of safety.

•

Use extreme caution when handling heavy parts. Provide adequate support and use

assistance during procedure. Ensure any lifting device used is in good condition and of

suitable load capacity. Keep clear of heavy parts supported only by lifting device.

•

Failure to follow these warnings may result in injury or death to personnel.

NOTE

•

Slider assembly weighs 1,400 lb (635 kg).

•

Note location of slider assembly on mounting blocks to aid installation.

1. Attach sling and lifting device to slider assembly. Loop one strap (Figure 9, Item 4) around center of beam (Fig-

ure 9, Item 3) and two straps (Figure 9, Item 1) on right and left twistlock housings (Figure 9, Item 2). Adjust

placement of straps until slider assembly is level when raised.

Figure 9.

Slider Assembly With Straps.

035

1

2

4

3

2