TB-9-3950-253-13-P

PALLETIZED LOAD SYSTEM TRUCK, M1075 and M1075A1 (PLS) AND HEAVY EXPANDED MOBILITY TACTICAL TRUCK, M1120, M1120A2, AND M1120A4 (HEMTT), ENHANCED CONTAINER HANDLING UNIT (E-CHU)

TECHNICAL BULLETIN; OPERATOR AND FIELD MAINTENANCE, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LIST

JULY 2009

TB-9-3950-253-13-P - Page 361 of 704

0035-13

TB 9-3950-253-13&P

0035

INSTALLATION – CONTINUED

Slider Assembly Installation – Continued

00035

WARNING

•

Lifting cables, chains, hooks, and slings used for lifting must be in good condition and of

suitable capacity.

•

Improper use of lifting equipment and improper attachment of cables may cause injury to

personnel and damage to equipment. Observe all standard rules of safety.

•

Use extreme caution when handling heavy parts. Provide adequate support and use

assistance during procedure. Ensure any lifting device used is in good condition and of

suitable load capacity. Keep clear of heavy parts supported only by lifting device.

•

Failure to follow these warnings may result in injury or death to personnel.

NOTE

•

Slider assembly weighs 1,400 lb (635 kg).

•

Install slider assembly on mounting blocks as noted during removal.

2. Attach sling and lifting device to slider assembly. Loop one strap (Figure 13, Item 4) around center of beam

(Figure 13, Item 3) and two straps (Figure 13, Item 1) on right and left twistlock housings (Figure 13, Item 2).

Adjust placement of straps until slider assembly is level when raised.

Figure 13.

Slider Assembly With Straps.

035

1

2

4

3

2