TM-5-2330-378-14-P
SEMITRAILER, LOWBED: 40 TON CONSTRUCTION EQUIPMENT TRANSPORTER M870 AND M870A1
TECHNICAL MANUAL; OPERATOR'S, UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)
JUNE 1999
TM-5-2330-378-14-P - Page 163 of 524
TM5-2330-378-14&P
4-34.
WIRING HARNESS REPLACEMENT (M870) (continued).
63,
Cut outtwo wire connectors (89) from between two black lead wires (87) and black lead wires (90).
64.
At left rear corner clearance light (83), pull circuit wire (68) through hole (85) in frame while assistant applies
grease atjunction box (21).
65.
Cut old circuit wire (68) and wire ends (78) from new circuitwire (77).
b. INSTALLATION
I .
At left rear corner clearance light (83), strip insulation from end of lead wire (84) to depth of connector (86).
2.
Strip insulation from circuit wire (77) to depth of connector (86).
3.
Install connector (86) on lead wire (84) and circuitwire (77) and crimp.
4.
Push excess wire into hole (85) in frame.
5.
At right rear corner clearance light (69), strip insulation from end of lead wire (70) to depth of connector (72).
6.
Strip insulation from circuit wire (65) to depth of connector (72).
7.
Install connector (72) on lead wire (70) and circuit wire (65) and crimp.
8.
Push excess circuit wire (65) into hole (71) in frame.
85
83
71
77
69
84
65
72
70
4-75
Back to Top
