TM-5-2350-377-13-P
ARMORED COMBAT EARTHMOVER (ACE), M9
TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST SUPPORTING THE HYDRAULIC BLADE FOLDER-TRACK TENSIONER
JUNE 2012
TM-5-2350-377-13-P - Page 256 of 404
GENERAL HYDRAULIC SYSTEM REPAIR METHODS - Continued
INSTALLATION PACKINGS (O-RINGS)
1.
Before installing a new packing, inspect the threads and packing seat (cavity) for nicks, cracks, and distortion.
Replace any damaged components.
2.
Ensure the packing is the correct type and size.
3.
Before installation, lubricate the new packing with engine lubricating oil.
4.
While installing the packing, always protect it from cuts or nicks. Do not install packing directly over threads
(Figure 6). If available, install packing over the plastic or rubber thread guard that is supplied with new fittings.
If no thread guard is available, protect the packing by wrapping the fitting threads with heavy, smooth, lint-free
paper. See the illustrations below.
5.
If a backup washer is used with the packing, it must be free of cuts, nicks, or distortion. An unserviceable
backup washer can cause the packing to distort or rupture when hydraulic pressure is applied and result in a
serious oil leak.
6.
After the packing is installed, inspect it for damage and replace it again if necessary. Also, ensure it is not
twisted or distorted.
CORRECT METHOD
INCORRECT METHOD
M0129HBF
Figure 6.
O-ring Installation.
TM 5-2350-377-13&P
0051
0051-6
Back to Top
