TM-5-2815-241-34-P
ENGINE, DIESEL NTC-290
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT, MAINTENANCE (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)
MARCH 1987
TM-5-2815-241-34-P - Page 66 of 738
TM 5-2815-241-34&P
OIL
PAN
REMOVAL
INITIAL SETUP
Tools
Personnel Required
Handle, ratchet, 1/2-inch drive
Socket, 1/2-inch, 1/2-inch drive
Socket, 9/16-inch, 1/2-inch drive
Socket, 5/8-inch, 1/2-inch drive
Socket, 3/4-inch, 1/2-inch drive
Socket, 13/16-inch, 1/2-inch drive
Wrench, box-end, 3/4-inch
Wrench, open-end, 1 7/8-inch
Two
ACTION
LOCATION
ITEM
REMARKS
NOTE
If oil pump has been removed, proceed to step 3.
1.
Oil pump bottom (1)
Nut (2)
2.
Oil pan (3)
Two screws (4), two
lockwashers (5),
suction tube with
flange (6) and
gasket (7)
3
Two screws (8), two
lockwashers (9), and
two nuts (10)
4
5
Four screws (11)
Using 1/2-inch drive 3/4-inch socket and
and four
ratchet handle, unscrew and take out.
lockwashers (12)
Discard lockwashers.
Four screws (13),
four lockwashers
(14), and spacer (15)
Using 1/2-inch drive 5/8-inch socket and
ratchet handle, unscrew and take out.
Discard lockwashers.
Using 1 7/8-inch open-end wrench, loosen
and disconnect.
Using 1/2-inch drive 9/16-inch socket and
ratchet handle, unscrew and take off.
Discard gasket and lockwashers.
Using 1/2-inch drive 13/16-inch socket,
ratchet handle, and 3/4-inch box-end
wrench, unscrew and take out.
Discard lockwashers.
2-44
Back to Top
