TM-5-3805-254-14-P-2

TRUCK, DUMP, 20 TON, 6X4, ON-OFF HIGHWAY 71,000 GVW, IHC MODEL F-5070 (CCE)

TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, GENERAL SUPPORT AND DEPT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS INFORMATION AND SUPPLEMENTAL MAINTENANCE INSTRUCTIONS)

JUNE 1980

TM-5-3805-254-14-P-2 - Page 124 of 894

TRUCK SERVICE MANUAL

BODIES AND CABS

Fig. 9.

Shock Absorber Removal

REINSTALL

Installation of Air Suspension System, Air Spring

Assembly, Air Valve Assembly, and Air Hoses are

reinstalled by reversing the removal procedures.

SHOCK ABSORBER

1.

With the shock absorber in proper posi-tion, replace

rear hinge shaft at rear of shock.

2.

Replace roll pin in hinge shaft, locking roll pin on

right hand side in nibs in bent-up ear.

3.

Replace hinge shaft at front of shock absorber,

driving shaft from right hand to left side.

Serrated

end of shaft to enter shock lever last.

Drive shaft

through two (2) washers and through shock absorber

loop.

4.

Replace snap ring at end of front hinge shaft.

5.

Line up left and right seat side panels maintaining

the 20” dimension over the side panels.

6.

Reassemble the seat cushion.

7.

Inflate air spring assembly by pushing in on control

valve and then remove shim.

Legend for Fig 10

Key

Description

1

CUSHION, Seat Assembly

2

CUSHION, Back Assembly

3

CLIP, Covering

4

SPRING, Air

5

RESERVOIR, Air

6

VALVE, W/Hoses, Air

7

PANEL, Seat, Right

8

PANEL, Seat, Left

9

BUSHING, Seat Lever, Left

10

INDICATOR, Ride

11

BUMPER, Rubber

12

BUSHING, Seat Lever, Right

13

PIN, Roll

14

PIN, Shock Absorber

Key

Description

15

ROLLER, W/Bushing

16

PIN, Roller

17

BUSHING, Shock Absorber

18

ABSORBER, W/Pin, Shock

19

LEVER

20

PIN, Seat Lever Drive

21

BUSHING, Seat Adjusting Lever

22

LEVER, W/Pins, Seat Adjuster

23

ROLLER, W/Bushing, Seat

24

PIN, Hinge

25

LEVER, W/Pins, Shock Absorber

26

BASE, W/Bushings, Seat

27

RISER, Seat

28

BUSHING, Seat Stabilizer

122