TM-5-3805-254-14-P-2

TRUCK, DUMP, 20 TON, 6X4, ON-OFF HIGHWAY 71,000 GVW, IHC MODEL F-5070 (CCE)

TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, GENERAL SUPPORT AND DEPT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS INFORMATION AND SUPPLEMENTAL MAINTENANCE INSTRUCTIONS)

JUNE 1980

TM-5-3805-254-14-P-2 - Page 520 of 894

TRUCK SERVICE MANUAL

Note

: Install enough shims to bring the plunger flush with

the fuel passage leaving it completely open for pump

calibration, Fig.

5-103.

Some throttle shafts do not have

a restriction plunger.

2. Install restriction plunger in the throttle shaft, if

used.

Torque plug to 40 to 55 inch pounds [4.5 to 6.2 No

m].

3. Install washer over shaft.

Insert the throttle shaft

In sleeve so the "ears" of the stop are curved downward

or if pin is used so open side of pin is down, lubricate

with fuel oil.

Note:

Counterbored port on PT (type G) throttle must go

4.

Install the snap ring and lock in the groove in front of

the throttle shaft cover plate.