TM-5-3895-371-24-P

BITUMINOUS DISTRIBUTOR BODY M918, MODEL D-63

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL WITH REPAIR PARTS AND SPECIAL TOOLS LIST

MARCH 1981

TM-5-3895-371-24-P - Page 170 of 330

TM 5-3895-371-24 & P

(13)

Tap the sides of the bolt hole counterbores lightly to break the gasket seal. Using a

screwdriver, remove seal assembly (51, fig. 3-26).

Figure 3-26. Removing Shaft Assembly.

(14)

Remove shaft seal (50, fig. 3-4) from seal assembly (51) using an arbor press and a 2-1/2

in. plug.

(15)

Remove O-ring (49) from flange.

(16)

Remove pump shaft and assembled parts, pump shaft (53), ball bearing (48), retaining

ring (47), retaining ring (12) and inner race of bearing (13) by pulling straight up from mounting flange

(55), as shown in figure 3-27.

(17)

Inspect bail bearing (48, fig. 3-27) for galling, roughness, or cage cracks. If damage is

evident, remove retaining rings (47) using snapring pliers and press ball bearing (48) from shaft.

Figure 3-27. Removing Shaft Seal

Retainer.

3-25