TM-5-3895-372-20
CONCRETE-MOBILE MIXER BODY M919, MODEL 8CM-24/F
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL
AUGUST 1980
TM-5-3895-372-20 - Page 414 of 694
TM 5-3895-372-20
CEMENT SYSTEM.
8-15.
CEMENT SYSTEM DRIVE MAINTENANCE (Continued).
LOCATION/ITEM
ACTION
REMARKS
D.
ASSEMBLY (Continued).
49. Coupling cover (76).
50. Square key (77).
51. Coupling half (78).
E.
INSTALLATION
52. Shaft (90).
53. Clutch handle (51).
54. Chain (80).
55. Coupling cover (76) and
(82).
56. Idler sprocket (89).
57. Idler bracket (88).
58. Idler spring (84).
59. Idler sprocket (43).
60. Idler bracket (40).
61. Idler spring (39).
62. Two chains (47) and (65).
Install.
Install.
Install and tighten socket
setscrew (79)
a.
Install and support.
b.
Install four hex bolts (94)
and (31), flat washer (30).
and (36), lockwashers (72)
and (35) with hex nuts (73)
and (34) and tighten.
a.
Install two halves on pins of
yoke (54).
b.
Install and tighten two hex
bolts (32) and 50) with hex
nuts (59) and (60).
a.
Install on sprockets of
coupling halves (78) and (81).
b.
Install offset chain link (64)
and chain link connection (66).
Assemble with four screws (95)
and square nuts (83).
Install and tighten hex bolt (91),
hex nut (85), lockwasher (86)
and flat washer (87).
Install and tighten hex bolt (33)
and locknut (98).
Install.
Install hex bolt, two hex nuts (37)
and (41), and lockwasher (38).
Install and tighten hex bolt (42)
and locknut (98).
Install.
a.
Install around sprockets and
over
top of two idler sprockets (43)
and (89).
b.
Install two offset chain links
(64)and chain link connections
(66).
Position in location marked
during disassembly.
Be sure two flange bearings
(71) and (93) are outside of
the mounting bracket
8-50
Back to Top
