TM-5-3895-372-20
CONCRETE-MOBILE MIXER BODY M919, MODEL 8CM-24/F
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL
AUGUST 1980
TM-5-3895-372-20 - Page 421 of 694
TM 5-3895-372-20
9-7. MIXER-AUGER SYSTEM MAINTENANCE TASK SUMMARY.
INITIAL SETUP
EQUIPMENT
CONDITION
APPLICABLE CONFIGURATIONS
PARAGRAPH
CONDITION DESCRIPTION
M919.
TM 5-3895372-10.
Mixer Trough Lowered.
TM 5-3895-372-10.
Cleanup Water Hose Removed
TEST EQUIPMENT
From Auger.
9-9A.
Mixer Trough Removed.
None.
9-10A.
Mix Auger Removed.
SPECIAL TOOLS
Mixer-Auger Wear Gage, NP2727000 (50663).
MATERIALSIPARTS (P/N)
Wear Blades Kit, NS3427-001 (50663).
Vee Blocks.
Surface Plate.
Tri-Square.
Stub-Shaft, NP3352002 (50663).
Drive Bushing, NP5033056 (50663).
Rubber Trough Repair Kit, NP2923000 (50663).
Miniskirt, NP2730004 (50663).
Shouldered Shaft, NP3352003 (50663).
Rubber Trough Patch Kit, NP3013000 (50663).
Rubber Trough Bottom, NP2186000 (50663).
PERSONNEL REQUIRED
SPECIAL ENVIRONMENTAL CONDITIONS
Two (MOS-62B20).
Vehicle Parked on Level Ground.
REFERENCES
GENERAL SAFETY INSTRUCTIONS
LO 5-3895-372-12.
Engine Off.
TM 5-3895-372-10.
Transmission in Neutral.
TM 5-3895-372-20P.
Park Brake Set.
TM 9-2320-273-10.
Wet Cement and Concrete Can Cause Bums.
Safety Glasses Should be Worn When Working
TROUBLESHOOTING REFERENCES
Around Cement.
Table 9-1.
LIST OF TASKS
TASK
TASK
TROUBLESHOOTING
NO.
TASK
REF
REF (TABLE)
1.
Wear Blades Replacement:
9-8
9-1
A.
Removal
9-8A
B.
Installation
9-8B
2.
Mixing Auger Assembly Maintenance:
9-9
9-1
A.
Removal
99A
B.
Installation
99B
C.
Operational Check
99C
9-4
Back to Top
