TM-5-3895-372-20
CONCRETE-MOBILE MIXER BODY M919, MODEL 8CM-24/F
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL
AUGUST 1980
TM-5-3895-372-20 - Page 429 of 694
TM 5-3895-372-20
MIXER-AUGER SYSTEM.
9-9. MIXING AUGER ASSEMBLY MAINTENANCE (Continued).
LOCATION/ITEM
ACTION
REMARKS
A. REMOVAL (Continued).
4.
Cotter pin (8) and
pin (9).
5.
Four bolts (20), washers
(21), and nuts (22).
6.
Two nuts (12), lockwashers
(13), and bolts (11).
7.
Two nuts (16), lockwashers
(17), and bolts (15).
8.
Two cotter pins (10)
and washers (18).
9.
Mixing auger (6).
10.
Nuts (12), and (16), lock-
washers (13) and (17),
and bolts (11) and (15).
11.
Mixing auger (6).
B. INSTALLATION.
12.
Mixing auger (6).
13.
Two nuts (12), lock-
washers (13) and bolts (11).
14.
Two nuts (16), lockwashers
(17) and bolts (15).
15.
Mixing auger (6).
a.
Remove.
b.
Lift out pulley (25) and
cable (7).
a.
Unscrew and remove pulley
bracket (24).
b.
Remove pulley housing (23)
from pulley bracket (24).
Unscrew and remove.
Unscrew and remove bracket
(14).
Remove from two pivot pins
(19).
Lift mixing auger (6) with
welded bracket (1) off pivot
pin (19). Once clear, lower
to ground.
Reinstall and tighten bracket
(14) to mixing auger (6).
Roll over and brackets (14)
and (1) will support mixing
auger (6).
Roll over with brackets (14)
and (1) facing upwards.
Remove.
Loosen.
Lift with suitable hoist and
slide brackets (14) and (1)
onto two pivot pins (19).
Take tension off cable (7)
and secure to ladder.
On right hand side.
On right hand side.
9-12
Back to Top
