TM-5-3895-372-20
CONCRETE-MOBILE MIXER BODY M919, MODEL 8CM-24/F
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL
AUGUST 1980
TM-5-3895-372-20 - Page 431 of 694
TM 5-3895-372-20
MIXER-AUGER SYSTEM.
9-9. MIXING AUGER ASSEMBLY MAINTENANCE (Continued).
LOCATION/ITEM
ACTION
REMARKS
B. INSTALLATION (Continued).
19.
Cable (7) and
pulley (25).
20.
Two hydraulic hoses (5).
21.
Clamp (2).
C. OPERATIONAL CHECK.
22.
Mixing auger (6).
23.
Mixer body.
24.
Hydraulic motor.
25.
Mixer body.
26.
Mixing auger (6).
a.
Install cable (7) around
pulley (25).
b.
Install pulley (25) into pulley
housing (23) with pin (9) and
cotter pin (8).
c.
Raise until there is tension on
cable and remove hoist.
Remove plugs and install.
a.
Position over two hydraulic
hoses (5).
b.
Install with lockwasher (4)
and nut (3).
Raise and lower. Lubricate if
necessary (refer to LO 5-3895-
372-12).
Start up (refer to TM 9-2320-
273-10 and TM 5-3895-372-10).
Activate; check connections of
two hydraulic hoses (5) for
leaks and proper functioning.
Shut down (refer to TM 9-2320
273-10 and TM 5-3895-372-10).
Raise and latch (refer to TM 5-
3895-372-10).
Be sure to connect hoses as
you marked at removal.
Retighten connections as
necessary.
Always latch mixing auger in vertical position and utilize safety chain
9-14
Back to Top
