TM-5-3895-372-20
CONCRETE-MOBILE MIXER BODY M919, MODEL 8CM-24/F
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL
AUGUST 1980
TM-5-3895-372-20 - Page 444 of 694
TM 5-3895-372-20
MIXER-AUGER SYSTEM.
9-11. MIXER AUGER REPAIR (Continued).
LOCATION/ITEM
ACTION
REMARKS
A. STRAIGHTENING.
1.
Mixer-auger (6).
Place in position, as shown,
Vee blocks must be on a level
with stub shaft (9) and
surface; use a surface plate if
shouldered shaft (2) resting
available.
on two vee blocks (1) and (10).
2.
Tri-square (4).
Position on surface plate with
Start near either end.
arm close to tube (5), but not
touching.
3.
Mixer-auger (6).
a.
Slowly turn while watching
If distance remains the same
the point where tri-square
for 3600 rotation, auger is
(4) was placed.
OK at that point.
b.
Select another point about
one-third towards the oppo-
site end and check again.
9-27
Back to Top
