TM-5-3895-372-20

CONCRETE-MOBILE MIXER BODY M919, MODEL 8CM-24/F

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL

AUGUST 1980

TM-5-3895-372-20 - Page 455 of 694

TM 5-3895-372-20

MIXER-AUGER SYSTEM.

9-13. RUBBER TROUGH REPAIR (Continued).

LOCATIONIITEM

ACTION

REMARKS

B. REPAIR OF OTHER AREAS.

NOTE

For this procedure, use kit NP 3D 13000.

11.

Damaged area (3).

Measure area as shown to

determine patch size required.

12.

Patch (2).

Cut to size and mark trough

area where patch will be applied.

13.

Patch (2) and trough

Apply rubber cement from kit.

Follow instructions on container

bottom (1).

14.

Patch (2).

a.Apply to trough bottom (1)

Keep patch tightly against

over damaged area (3)

trough bottom.

b.Drill 9/32” holes as shown

holes should be a maximum

thru patch (2) and trough

of two inches apart.

Bottom (1) around damaged

area (3) and around outer

edge of patch (2)

15.

Screws (6), washers

Install in each hole you drilled

Tighten securely.

(4), and nuts (5).

Thru the patch (2) and trough

bottom (1).

9-38