TM-5-5420-202-20-2

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 2 OF 4

OCTOBER 1985

TM-5-5420-202-20-2 - Page 361 of 734

TM 5-5420-202-20-2

SERVICE DUST DETECTOR FILTER STRIP (Sheet 1 of 2)

SUPPLIES:

Pipe cleaner (Item 75, Appendix D)

Tubing, non-metallic (Item 78, Appendix D)

Wire, 0.030 inch diameter (Item 63, Appendix D)

Cloth (Item 12, Appendix D)

Dry cleaning solvent (Item 55, Appendix D)

Goggles (Item 70, Appendix D)

Rubber gloves (Item 69, Appendix D)

PRELIMINARY PROCEDURE:

Remove dust detector filter strip and cover (page 7-130.11)

SERVICE:

1.

2.

3.

Dry cleaning solvent P-D-680 is

toxic and flammable.

Wear pro-

tective goggles and gloves and use

only in a well-ventilated area.

Avoid contact with skin, eyes, and

clothes and don’t breathe vapors.

Do not use near open flame or

excessive heat. The flash point for

Type #1 Dry Cleaning Solvent is

100°F (38°C) and for Type #2 is

138°F (50°C). If you become dizzy

while using cleaning solvent, get

fresh air immediately and get

medical aid. If contact with eyes

is made, wash your eyes with water

and get medical aid immediately.

Using clean cloth dampened with cleaning

solvent , clean cover (A) and mount-

ing face of compressor housing (B).

Inspect compressor housing chamber (C)

for contamination. Clean chamber (C) as

required.

Using pipe cleaner clean compressor

housing orifice chamber (C). Use wire

to clean orifice (D). Blow out chamber

(C) and orifice (D) by mouth, using a short

piece of tubing.

Go on to Sheet 2

7-130.14

Change 1