TM-5-5420-202-20-2

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 2 OF 4

OCTOBER 1985

TM-5-5420-202-20-2 - Page 397 of 734

TM 5-5420-202 -20-2

FUEL RETURN HOSE (RIGHT TANK) REPLACEMENT (Sheet 2 of 2)

NOTE

Put rags under each connection before

removing hose end fittings.

REMOVAL:

1.

2.

3.

Using 1/2 inch socket, loosen and remove

bolt and lockwasher (A) from hose clamp (B).

Using 1-1/2 inch open end wrench

on hose and fitting (C), and 1-1/2

inch open end wrench on fitting (D),

hold hose at point (C) while loosening

fitting (D). Slide fitting (D) away from

hose and fitting (C).

Using 1-3/8 inch open end wrench,

loosen fitting (with hose) (E). Remove

hose.

INSTALLATION:

1.

2.

3.

4.

5.

6.

7.

Lightly coat threads of both male hose ends with sealing compound.

Using 1-3/8 inch open end wrench, secure fitting (with hose) (A).

Using 1/2 inch socket, secure clamp (B) with bolt and lockwasher (C).

Using 1-1/2 inch open end wrench on hose and fitting (D), and 1-1/2 inch open end wrench

on fitting (E), hold hose at point (D) while securing fitting (E).

Service fuel tanks (TM 5-5420-202-10).

Ground hop engine (page 5-25) and allow

it to run for brief time while checking for

leaks. If leak is detected, stop engine and

tighten fitting. If fittings do not leak, disconnect

ground hop (page 5-40).

Replace powerplant (page 5-14).

End of Task

7-162