TM-5-5420-202-20-2

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 2 OF 4

OCTOBER 1985

TM-5-5420-202-20-2 - Page 401 of 734

TM 5-5420-202-20-2

ENGINE FUEL RETURN SELECTOR COCK REPLACEMENT (Sheet 4 of 4)

5.

6.

7.

8.

9.

10.

11.

12.

13.

14.

15.

16.

17.

18.

Position instruction plate (E) on selector

cock (D) with word BOTH at engine fuel

return tube elbow (center outlet).

Position pointer assembly (F) at BOTH

position.

NOTE

Check to be sure all three openings in selector

cock are open.

Install headless straight pin (G) in pointer assembly (F) and secure with cotter pin.

Using slip joint pliers, secure pointer assembly (F) in BOTH position with lockwire (H).

Remove selector cock (D) from vise.

Using 7/16 inch socket, secure selector cock on mounting bracket (J) with three screws

and lockwashers (K) and spacers (L).

Using 1-3/8 inch wrench on fitting (M) and 1-1/2 inch wrench on fitting (N), hold

fitting (M) in a fixed position while securing fitting (N).

Using one 1-1/2 inch wrench on fitting (P) and other 1-1/2 inch wrench on fitting (Q),

hold fitting (Q) in a fixed position while securing fitting (P).

Using 1 inch wrench, secure tube fitting (R).

Service fuel tanks (TM 5-5420-202-10).

Attach ground hop kit (page 5-27).

Start engine and allow it to run for a brief time while checking for leaks.

Disconnect ground hop kit (page 5-40).

Replace powerplant (page 5-14).

End of Task

7-166