TM-5-5420-202-20-2

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 2 OF 4

OCTOBER 1985

  TM-5-5420-202-20-2 - Page 532 of 734

TM 5-5420-202-20-2
ENGINE IDLE ADJUSTMENT (Sheet 1 of 1)
TOOLS: 1/2 in. combination box and open end wrench
Flat-tip screwdriver
FABRICATED TOOLS:
Throttle linkage adjusting go/no go gage
(Figure F-3, Appendix F)
REFERENCE:
TM 5-5420-202-10
PRELIMINARY PROCEDURES:
Engage parking brake (TM 5-5420-202-10)
Remove upper engine access cover (page 17-11)
Block tracks to prevent vehicle movement (TM 5-5420-202-10)
Start engine, run at idle (TM 5-5420-202-10)
ADJUSTMENT:
1.
Using 3/16 inch end of fabricated gage, measure distance between stop pin (A) and bracket
shoulder (B).
2.
3.
4.
5.
6.
7.
End
If distance is more than or less than 3/16 inch, use wrench and loosen jamnut (C) on idle
adjustment screw (D).
Using screwdriver, turn screw (D) to the right to increase distance, and to the left to decrease
distance.
Using wrench, tighten jamnut (C).
Check idle speed.
If it is not between 700-750 rpm (shown on tachometer), notify support
maintenance.
Stop engine (TM 5-5420-202-10).
Install upper engine access cover (page 17-12).
of Task
7-297


Back to Top