TM-5-5420-202-20-2

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 2 OF 4

OCTOBER 1985

TM-5-5420-202-20-2 - Page 644 of 734

TM 5-5420-202-20.2

EXHAUST PIPE (RIGHT SIDE) REPLACEMENT (Sheet 3 of 4)

INSTALLATION:

1.

Position packing (A) and clamp (B) onto pipe (C) and, using flat-tip screwdriver, tighten

screw on clamp (B) securing packing to pipe (C).

2.

Check insulation halves (D) and all attaching hardware for damage. Replace if necessary.

3.

Position insulation halves (D) onto exhaust pipe (C).

4.

5.

6.

7.

Using 5/16 inch wrench and cross-tip screwdriver, install 14 screws (E), each with two

flat washers (F), lockwasher (G), and nut (H), to hold insulation halves (D) to

exhaust pipe (C).

Position new gasket (J) onto turbosupercharger

housing (K).

Position exhaust pipe (C) with installed

insulation halves (D) onto turbosupercharger

housing (K). Make sure exhaust port

(L) is pointing up.

Using 9/16 inch socket and open end

wrench, install six nuts (M) securing

exhaust pipe to housing.

Go on to Sheet .4

8-11