TM-5-5420-202-20-2
M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 2 OF 4
OCTOBER 1985
TM-5-5420-202-20-2 - Page 640 of 734
TM 5-5420-202-20-2
EXHAUST PIPE (LEFT SIDE) REPLACEMENT (Sheet 3 of 4)
INSULATION :
1.
Position packing (A) and clamp (B) onto pipe (C) and, using flat-tip screwdriver, tighten
screw on clamp (B), securing packing to pipe (C).
2.
Check insulation halves (D) and all attaching hardware for damage. Replace if necessary.
4.
5.
6.
7.
Using wrench and cross-tip screwdriver, install 14 screws
(F), one lockwasher (G), and one nut (H) to hold insulation
(C).
3.
Position insulation halves (D) onto
exhaust pipe (C).
(E), each with two flat washers
halves (D) to exhaust pipe
Position new gasket (J) onto turbosupercharger housing (K).
Slide exhaust pipe extension (L) into
tube (M) as far as it will go.
Position exhaust pipe (C) with installed
insulation halves (D) onto turbosupercharger
housing (K).
Make sure exhaust port
(N) is pointing up.
Go on to Sheet 4
8-7
Back to Top
