TM-5-5420-202-20-2
M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 2 OF 4
OCTOBER 1985
TM-5-5420-202-20-2 - Page 79 of 734
TM 5-5420-202-20-2
ENGINE MOUNTS (LEFT AND RIGHT) REPLACEMENT (Sheet 2 of 3)
2.
3.
4.
Using 1-1/8 inch open end wrench to hold nut
(D) and 1-1/8 inch socket on bolt (E), remove
nut (D) and bolt (E) from bracket (F).
While holding bushing (G) with 3/4 inch drive
T-slide and 36 inch extension bar, use 1-1/8
inch socket to remove bolt (H) and washer
(J) from bracket (F).
Remove bushing (G), mount (K), mounting
(L), and mount (M) from engine assembly.
CLEANING AND INSPECTION:
Dry cleaning solvent P-D-680 is toxic and
flammable.
To prevent personal injury, wear
protective goggles and gloves and use only in a
well-ventilated area. Avoid contact with skin,
eyes, and clothes and don’t breathe vapors. Do
not use near open flame or excessive heat. The
flash point for Type #1 Dry Cleaning Solvent is
100°F (38°C) and for Type #2 is 138°F (50°C).
If you become dizzy while using cleaning
sovent, get fresh air immediately and get
medical aid. If contact with eyes is made, wash
your eyes with water and get medical aid
immediately.
1.
Clean all parts with dry cleaning solvent and
wipe dry with clean rag.
2.
Inspect bushing, mounts, and mountings for
nicks and burrs. Replace damaged parts.
Go on to Sheet 3
6-6
Back to Top
