TM-5-5420-202-20-2
M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 2 OF 4
OCTOBER 1985
TM-5-5420-202-20-2 - Page 96 of 734
TM 5-5420-202-20-2
ENGINE OIL COOLER (LEFT AND RIGHT) REPLACEMENT (Sheet 5 of 6)
10.
Using 1/2 inch socket with extension
through harness and into bracket, install
two lockwashers and screws (E).
11.
12.
13.
14.
15.
16.
17.
Using 9/16 inch wrench, install oil cooler
vent hose (F) at top of cooler.
Remove plastic material and masking tape
from ends of hose (G) and oil cooler connector
(H).
Using 1/2 inch socket, install three nuts
(J) securing gasket and oil cooler connector
(H) to oil cooler.
Using 1-1/2 inch wrench, install hose (G) at
oil cooler connector (H).
Remove plastic material and masking tape
from ends of hose (K) and oil cooler connector
(L).
Using 1/2 inch socket, install three nuts
(M) securing gasket and oil cooler connector
(L) to oil cooler.
Using 1-1/2 inch wrench, install hose (K) to
oil cooler connector (L).
Go on to Sheet 6
6-23
Back to Top
