TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

TM-5-5420-202-20-3 - Page 312 of 1060

TM 5-5420-202-20-3

BULKHEAD CABLE DISCONNECT (Sheet 1 of 29

TOOLS:

Spanner wrench

Flat-tip screwdriver

9/16 in. socket with 1/2 in. drive

Ratchet with 1/2 in. drive

SUPPLIES:

Lockwashers (11 required)

PRELIMINARY PROCEDURES:

Remove three ground straps from battery negative ter-

minals (page 10-268)

Remove commander’s seat (page 17-78)

Remove right bulkhead access cover (page 17-2)

QUADRANTS REMOVED

FOR CLARITY

REMOVAL:

1.

Using 9/16 inch socket

remove seven screws (A) and lockwashers

(B) securing connector cover plate (C)

to bulkhead.

2.

Pull connector plate cover (C) and its

gasket (D) away from bulkhead. Harness

assemblies inside bulkhead will come

with cover plate (C) since they are

attached to it.

Go on to Sheet 2

NOTE

To remove either of the two middle

connectors on the cover plate, you must

first remove either the top or

connector, as required, to get a

wrench on the desired connector.

bottom

spanner

3.

Using spanner wrench, disconnect and

remove connector (E) at back side of

cover plate (C).

4.

Using flat-tip screwdriver, remove four

screws (F) and lockwashers (G) securing

corre spending connector (H) and gasket

(J) at front side of cover plate (C).

10-269