TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

TM-5-5420-202-20-3 - Page 525 of 1060

TM 5-5420-202-20-3

SHIFTING CONTROL TO FORWARD INBOARD BELL CRANK ASSEMBLY ROD REPLACEMENT

(Sheet 4 of 5)

ADJUSTMENT:

1.

2.

NOTE

When adjusting rod ends, make certain

that threads on control tubes extend

past the gage opening in the rod end

to ensure a positive grip.

Using two 9/16 inch wrenches and steel tape, adjust rod ends (A) to obtain the same

center-to-center distance between holes as measured and recorded in steps 5 and 6,

REMOVAL.

Using torque wrench and crow foot adapter, tighten nuts (B) against rod ends (A) to 16-

18 lb-ft (23-24 N·m).

Go on to Sheet 5

11-28

TA249294