TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

TM-5-5420-202-20-3 - Page 533 of 1060

TM 5-5420-202-20-3

SHIFTING CONTROL REAR ROD AND LEVERS REPLACEMENT (Sheet 3 of 4)

INSTALLATION:

Using 9/16 inch wrench, install jamnut

(A) onto rod (B).

Using 9/16 inch wrench, install rod

(C) onto rod (B) past witness holes.

Position rod end (C) into lever (D).

Using 9/16 inch wrench, install bolt

end

NOTE

1.

2.

3.

4.

(E) through lever (D) and rod end (C).

5.

Make

sure

that

clevis

opening on lever (F) is

alined with spline on trans-

mission stud (G) before in-

stalling lever (F).

Install lever (F) onto transmission shaft

stud (G). Using hand, install screw (H)

6.

7.

8.

through lever (F).

Using 7/16 inch wrench, install screw

(J) and jamnut (K) into lever (F).

Install washer (L) and nut (M) onto screw

(H). Using two 9/16 inch wrenches, tighten

nut (M).

Using 9/16 inch wrench, install washer

and nut (N) onto transmission shaft

9.

stud (G).

Using pliers, install new cotter pin (P)

through nut (N) and transmission shaft

stud (G) .

TA249302

11-36