TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

TM-5-5420-202-20-3 - Page 624 of 1060

TM 5-5420-202-20-3

UNIVERSAL JOINT REPLACEMENT (Sheet 4.1 of 7)

NOTE

4.

5.

6.

7.

8.

9.

Check

be on

staking of pin

flange (D) and

(C). Stake marks should

overlapping pin (C) on

four sides.

If not staked properly, use fabricated center

punch and stake pin (C) four places, equally

spaced on flange (D). If chamfer on flange

(D) is so large that metal does not

mushroom over pin (C) when staked, replace

quick-disconnect clamp (A).

Inspect quick-disconnect clamp (A) for cracks,

breaks, or sprung hinge. If damaged, replace

quick-disconnect clamp (A).

Close quick-disconnect clamp (A) and install

screw (E) finger tight.

Using thickness gage, check clearance

between flange (F) and flange (D). Clearance

must be 0.000 to 0.005 inch. If more than

0.005 inch, proceed to step 9. If clearance is

within tolerance, go to sheet 4.2.

Using oxy-acetylene welding equipment,

brazing alloy and welding flux, braze a bead

(G) across top of flange (F).

10. Using file, file bead (G) down until metal to

metal contact exists between flange (F) and

flange (D).

Go on to Sheet 4.2

Change 3

12-18.1