TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

TM-5-5420-202-20-3 - Page 697 of 1060

TM 5-5420-202-20-3

BRAKE LEFT HAND SLAVE CYLINDER AND TUBE ASSEMBLY REPLACEMENT (Sheet 3 of 4)

CLEANING AND INSPECTION:

WARNING

Dry cleaning solvent P-D-680 is toxic and flammable.

To prevent personal injury, wear

protective goggles and gloves and use only in a well-ventilated area. Avoid contact with skin,

eyes, and clothes and don't breathe vapors.

Do not use near open flame or excessive heat. The

flash point for Type #1 Dry Cleaning Solvent is 100°F (38°C) and for Type #2 is 138°F (50°C).

If you become dizzy while using cleaning solvent, get fresh air immediately and get medical aid.

If contact with eyes is made, wash your eyes with water and get medical aid immediately.

1.

Clean all metallic parts in dry cleaning

solvent.

2.

Inspect all parts for damage or wear.

Replace all unserviceable parts.

3.

Inspect tube assembly nut for cracks.

Replace tube assembly if any cracks

are found.

INSTALLATION:

1.

Insert new packing (A) in groove of

slave cylinder (B).

2.

Position and slide slave cylinder (B)

down over housing assembly push rod (C).

Wiggle it back and forth while pushing

down. Push slave cylinder (B) forward

when on housing assembly (D), then

pull back to make sure catch (E) engages

in housing assembly (D).

3.

Tighten mounting nut (F) to stud (G)

finger tight.

4.

Using 9/16 inch socket, tighten mounting

nut (F).

Go on to Sheet 4

13-56