TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

TM-5-5420-202-20-3 - Page 700 of 1060

BRAKE RIGHT HAND SLAVE CYLINDER AND TUBE ASSEMBLY

1.

Position container under tube (A) and

tee (B) to catch brake fluid.

2.

Using 11/16 inch wrench, disconnect

nut of tube assembly (A) from tee (B).

NOTE

Allow brake fluid to drain.

of fluid in accordance with

cedures.

TM 5-5420-202-20-3

REPLACEMENT (Sheet 2 of 6)

3.

Using 7/16 inch socket, remove screw

(C), lockwasher (D), and clamp (E).

4.

Using 13/16 inch box wrench, loosen

bolt (F) from slave cylinder.

5.

Remove bolt (F), tube (A), and two gaskets

(G) as an assembly from slave cylinder (H).

Throw gaskets (G) away.

6. Installl plastic cap on tee (B).

7.

Install plastic plug in nut of tube assembly

(A) and masking tape on parts in other

end.

8.

Using 9/16 inch socket, remove screw

(J), lockwasher (K), and bracket (L).

NOTE

Replace screw (J) and lockwasher (K) to hold adjusting screw lock plate in

place until installation of bracket (L).

Go on to Sheet 3

TA249444

13-59