TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

TM-5-5420-202-20-3 - Page 792 of 1060

14-7

TM 5-5420-202-20-3

ROADWHEEL ARM REPLACEMENT (Sheet 6 of 7)

1.

Remove covering from roadwheel support

housing opening.

2.

Apply a light coat of grease to outer edge of

new inner grease seai.

3.

Position inner grease seal (A) into roadwheel

housing (B) opening so BACK of seal (A) goes in

towards hull. You should be able to see

FRONT of seal (A) as you look into housing.

4 .

Using oil seal replacer and handle tap lightly

on handle with hammer until inner seal has

bottomed in housing (B).

5.

Coat all parts on upper spindle (C) with

grease.

6.

Install new gasket (D) to mounting face of

retainer (E).

CAUTION

Do not use excessive force while

installing roadwheel arm; damage

to seal may result.

NOTE

Upper spindIe (C) must be properly

alined with support housing (B)

while roadwheel arm (F) is being

installed.

7.

Using two persons, install upper spindle (C)

completely into support housing (B).

G

O

on to Sheet 7