TM-5-5420-202-20-4

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 4 OF 4

OCTOBER 1985

TM-5-5420-202-20-4 - Page 460 of 534

TM 5-5420-202-20-4

MATERIAL

STOCK

DESCRIPTION

FABRICATING REQUIREMENT

P/N: 7379233

1 EA QUICK DISCONNECT

NSN: 2520-00-737-9233

CUT EARS OFF QUICK DISCONNECT

FLANGE

FLANGE 1/4” OUTSIDE LIP (6.5”

NOTE: MAY BE

DIA).

SALVAGED

FLANGE.

2.

MACHINE FLAT SIDE UNTIL TOOL

P/N: 10904402

6 EA DECK CLIP

THICKNESS IS APPROXIMATELY 1” TO

NSN: 2510-00-020-2331

1-5/32”.

(THIS STEP OPTIONAL IF

NOTE: CLIPS MAY

MACHINE SHOP SERVICES ARE NOT

BE MADE

AVAILABLE.)

FROM ANGLE

IRON OR

3.

CUT RING IN THREE PLACES SO THAT

FORMED

EACH LARGE PIECE HAS 14 SPLINE

FROM

TEETH.

1/4” STEEL.

4.

DEBURR SPLINE TEETH EDGES WITH

WIRE BRUSH OR WIRE WHEEL IF

NECESSARY.

5.

USING BENCH GRINDER OR

EQUIVALENT, GRIND APPROXIMATELY

3” RADIUS INTO SHORT ARM OF DECK

CLIP. DEBURR EDGES.

6.

CUT OFF DECK CLIP TO A LENGTH OF

1-5/16”.

7.

IF US IN ANGLE IRON. FABRICATE

GUIDE CLIPS

GRIND AS IN STEP 4.

Figure F-4. Final drive adapter hook-up tool (Sheet 1 of 2).

Change

4

F-4