TM-5-5420-202-20-4
M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 4 OF 4
OCTOBER 1985
TM-5-5420-202-20-4 - Page 450 of 534
TM 5-5420-202-20-4
GENERAL MAINTENANCE (Sheet 33 of 33)
Small Screws in Closely Spaced, Closed Geometrical Pattern Single Wire Safety Wiring (Sheet 1 of 1)
TOOLS:
Slip joint pliers
Diagonal cutting pliers
SUPPLIES:
Lockwire
1.
Using diagonal cutting pliers, cut piece of lockwire long enough to hold the screws in
the pattern being wired.
2.
Using slip joint pliers, run wire through
nuts, leaving enough wire pigtailing
from nut (A) so completed lacing may
be secured by twisting.
3.
Using slip joint pliers, twist wire at
least six times.
4.
Using diagonal cutting pliers, cut wire leaving a pigtail from 1/4 to 1/2 inch long.
5.
Bend pigtail back under to prevent it from becoming a snag.
End of Task
C-34
TA248929
Back to Top
