TM-5-5420-202-20-4

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 4 OF 4

OCTOBER 1985

  TM-5-5420-202-20-4 - Page 446 of 534

TM 5-5420-202-20-4
GENERAL MAINTENANCE (Sheet 29 of 33)
Single Fastener Double-Twist Safety Wiring (Sheet 1 of 1)
TOOLS:
Slip joint pliers
Diagonal cutting pliers
SUPPLIES:
Lockwire
1.
4.
5.
6.
Using diagonal cutting pliers, cut piece of lockwire about 24 inches long.
End of Task
C-30
2.
Run wire through drilled bolt head (A),
keeping length of free wire ends the
same.
3.
Using slip joint pliers, twist wire until
wire twist almost reaches drilled hole
(B) in plate.
Run one leg of wire through drilled
hole (B) in plate.
Using slip joint pliers, twist wire at
least six times.
Using diagonal cutting pliers, cut wire
leaving a pigtail from 1/4 to 1/2 inch
long.
7.
Bend pigtail back under to prevent it
from becoming a snag.
TA248925


Back to Top