TM-5-5420-202-20-4
M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 4 OF 4
OCTOBER 1985
TM-5-5420-202-20-4 - Page 82 of 534
TM 5-5420-202-20-4
PERSONNEL SEAT AND SEAT MOUNT ASSEMBLY REPLACEMENT (Sheet 1 of 2)
TOOLS: 7/16 in. combination box and open end wrench
1/2 in. combination box and open end wrench (2 required)
9/16 in. open end wrench
7/16 in. socket with 1/2 in. drive
Ratchet with 1/2 in. drive
Putty knife
SUPPLIES:
Adhesive (Item 4, Appendix D)
NOTE
This procedure covers the replacement of the
commander’s seat and seat mount assembly.
Replacement of the driver’s seat and seat
mount assembly is similar.
Using two 1/2 inch wrenches, remove
two bolts, flat washers, lockwashers,
and nuts (A).
Using putty knife, remove pad (B).
Using 9/16 inch wrench, remove two
screws, lockwashers and washers (C).
Remove seat and seat mount assembly (D)
from vehicle.
Using 7/16 inch wrench and socket,
remove two screws (E) and nuts (F)
securing rack (G).
Remove rack (G) and seat (H).
Go on to Sheet 2
17-56
TA248587
Back to Top
