TM-5-5420-202-20-4
M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 4 OF 4
OCTOBER 1985
TM-5-5420-202-20-4 - Page 86 of 534
TM 5-5420-202-20-4
PERSONNEL SEAT ASSEMBLY REPAIR (Sheet 3 of 5)
10.
Using hammer and 1/8 inch punch, remove
two short pins (L) from handle (M).
11.
Remove handle (M), latch (N), and spring (P).
12.
Using hammer and 1/4 inch punch, drive
out eight nuts (Q).
13.
Inspect all parts
for damage or wear;
replace parts as required.
ASSEMBLY:
1.
2.
3. “
4.
5.
6.
Using hammer and 1/8 inch punch, install eight nuts (A).
Using hammer, install new short pin (B) in handle (C).
Position spring (D) on handle (C).
.
Position handle (C) through hole in seat (E).
Position latch (F) on handle (C) with
holes alined.
Using hammer and punch, install new short
pin (G) in handle (C).
Go on to Sheet 4
17-60
TA248591
Back to Top
