TM-5-5420-203-14

BRIDGE, ARMORED VEHICLE LAUNCHED, SCISSORING TYPE CLASS 60 & CLASS 70 ALUMINUM, 60 FOOT SPAN; FOR M48A5 AND M60 LAUNCHER

TECHNICAL MANUAL; OPERATOR’S, UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE

JUNE 1991

TM-5-5420-203-14 - Page 181 of 298

TM 5-5420-203-14

CABLE BEAM REPLACEMENT

(Sheet 2 of 2)

g. Repeat step f. for opposite side of cable

beam (4). Slide beam (4) clear of clip

angles and quadrant struts (9). Set beam (4)

aside.

INSTALLATION

INSTALL CABLE BEAM (4).

a.

b.

c.

d.

e.

f.

Position cable beam (4) on clip angles of

center sections. Aline struts (9) to fit into

slots located on cable beam (4). Slide cable

beam (4) forward to aline holes in clip angles

and

StrutS

(9).

Install two bolts

(8) thru

cable beam (4)

passing thru struts (9).

Install six bolts (12) thru clip angles of

center section securing cable beam (4) in

position.

Thread two nuts (7) on two bolts (8).

Tighten nuts (7). Install two retainers (6) in

two bolts (8).

Thread six nuts (11) on six bolts (12).

Tighten nuts (11). Install six retainers (10)

in six bolts (12).

Place equalizer plate (3) so hole alines in

equalizer plate and cable beam (4). Install

equalizer plate (3) to cable beam (4). Install

equalizer plate retainer pin (1) in equalizer

plate pin (2).

END OF TASK

3-15