TM-5-5420-203-14

BRIDGE, ARMORED VEHICLE LAUNCHED, SCISSORING TYPE CLASS 60 & CLASS 70 ALUMINUM, 60 FOOT SPAN; FOR M48A5 AND M60 LAUNCHER

TECHNICAL MANUAL; OPERATOR’S, UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE

JUNE 1991

TM-5-5420-203-14 - Page 183 of 298

TM 5-5420-203-14

END PANEL CURB REPLACEMENT

TOOLS

/EQ

UIPMENT

General Mechanics Tool Box SC 5 180-90-N26

SUPPLIES:

Lock Washer (item 5, Appendix E) (5 required)

EQUIPMENT CONDITIONS:

None.

PERSONNEL:

Two

REMOVAL

REMOVE END PANEL CURB (3).

a.

b.

c.

d.

NOTE

End panel curbs have extra mounting holes

located in base for use in allowing mounting

on either side of end panels.

Remove four nuts (1) from four bolts (2)

securing end panel curb (3) to end panel (4).

Remove four lock washers (5) from four

bolts (2). Remove four bolts (2) with four flat

washers (6) installed from end panel (4).

Remove end panel curb (3) from end panel

(4). Discard lock washers (5).

Remove nut (7) and lock washer (8) from

short bolt (9). Remove bolt (9). Discard lock

washer.

Remove flat washer (10) from bolt (9).

INSTALLATION

INSTALL END PANEL CURB (3).

a.

b.

c.

Position end panel curb (3) so holes aline in

curb and end panel (4).

Install four flat washers (6) on four bolts

(2). Insert bolts from the bottom of the deck

extrusions up as shown.

Install four new lock washers (5) on bolts

(2). Thread four nuts (1) on bolts (2).

d.

e.

Tighten four nuts (1) on bolts (2).

Tighten four nuts (l).

Place flat washer (10) on bolt (9). Install

bolt (9) in end panel and curb (3) from

bottom up.

Install new lock washer (8) on bolt (9).

f.

Thread nut (7) on bolt (9). Tighten nut/

bolt assembly.

END OF TASK

3-17