TM-5-5420-203-14

BRIDGE, ARMORED VEHICLE LAUNCHED, SCISSORING TYPE CLASS 60 & CLASS 70 ALUMINUM, 60 FOOT SPAN; FOR M48A5 AND M60 LAUNCHER

TECHNICAL MANUAL; OPERATOR’S, UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE

JUNE 1991

TM-5-5420-203-14 - Page 208 of 298

TM 5-5420-203-14

FAR-SHORE CENTER SECTION TRANSVERSE BRACE REPLACEMENT (Sheet 4 of 4)

m.

n.

o.

P,

q.

r.

s.

NOTE

A second crew member is required for

the following task.

Insert

flat

end of equalizer plate (14) into

cavity located on cable beam (15). Install

equalizer plate pin (13) in cable beam (15)

securing quaker plate and attached cables (11).

Install equalizer plate pin retainer (12) in

pin (13).

NOTE

The

direction of the rotation of the

cable strands are critical. The left cable

is not designed for use on the right and

vice versa

Note the rotation of the

strands of the cable when replacing

cables, check the current placement

with Detail A and B and ensure they

are installed properly.

install cable retainer (9) in flanges (10) of

quadrant (5) securing cables (11) in

position.

Install two pins (8) through flanges

(10) locking cable retainer (9) in

position.

install two pin retainers (7) in pins

(8). If second two pin retainers (7)

were removed, install second two pin

retainers (7) in opposite ends of pins (8).

Position transverse brace (2) on one side

of clip angles.

install four bolts (1) securing brace (2).

Tighten bolts.

END OF TASK

3-42