TM-5-5420-228-24
LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60
TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL
AUGUST 1985
TM-5-5420-228-24 - Page 323 of 750
TM 5-5420-228-24
OVERHEAD CYLINDER HOSE ASSEMBLIES (CL, CM, CN, AND CO) AND HYDRAULICS
REPLACEMENT (Sheet 2 of 8)
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
18.
Holding tee (F) with 12 inch adjustable
wrench, use 1-1/8 inch wrench to remove
adapter (C) and collar (G) from tee (F).
Holding elbow (H) with 1-1/8 inch wrench,
use 1-1/4 inch wrench to remove hose
assembly (J) from elbow (H).
Holding tee (F) with 12 inch adjustable
wrench, use 1-1/8 inch wrench to remove
elbow (H) and collar (K).
Holding nipple (L) with 1-1/8 inch
wrench, use 12 inch adjustable wrench
to remove tee (F) from nipple (L).
Holding elbow (M) with 12 inch adjustable
wrench, use 1-1/8 inch wrench to remove
nipple (L) from elbow (M).
Using 12 inch adjustable wrench, remove
elbow (M) from relief valve (N).
Holding adapter (P) with 1-1/8 inch wrench, use 1-1/4 inch wrench
to remove hose assembly (Q).
Holding relief valve (E) with 15 inch adjustable wrench, use 1-1/8 inch wrench to remove
adapter (P) and collar (R).
Using 12 inch adjustable wrench, remove elbow (S) and attached nipple (T) and relief
valve (E) from overhead cylinder (U).
Using care not to cause damage, clamp relief valve (E) in vise.
Holding nipple (T) with 1-1/8 inch wrench, use 12 inch adjustable wrench to remove
elbow (S) from nipple (T).
Using 1-1/8 inch wrench, remove nipple (T) from relief valve (E).
Remove relief valve (E) from vise.
Holding elbow (V) with 12 inch adjustable wrench, use 1-1/4 inch wrench to remove hose
assembly (W) from elbow (V).
Holding elbow (X) with 15 inch adjustable wrench, use 12 inch adjustable wrench to remove
elbow (V) and collar (Y).
Go on to Sheet 3
TA251524
3-126
Back to Top
